Test 6B - Mic Warning Light Faulty
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION
. For appropriate wiring diagram, see WIRING DIAGRAMS
at end of article.
- Turn ignition off. Disconnect Mechanical Instrument Cluster (MIC) connectors. Remove inoperative warning light bulb(s). Replace burned out bulb(s) as necessary and perform VERIFICATION PROCEDURE VER-1.
- If bulbs are okay, check instrument cluster printed circuit board and its connectors. If printed circuit board is not okay, replace defective circuit board. Perform VERIFICATION PROCEDURE VER-1. If printed circuit board is okay, replace instrument cluster. Perform VERIFICATION PROCEDURE VER-1.