Test 8E - Bus Short To 5 Volts

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION in BODY CONTROL COMPUTER. For wiring diagrams, see article in ENGINE PERFORMANCE:

WIRING DIAGRAMS - 2.0L & 2.4L
WIRING DIAGRAMS - 2.5L V6
After each repair, perform TEST VER-1 .

CAUTION: Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
1. If resistance is more than 5 ohms, repair open Black/Light Green wire. If resistance is less than 5 ohms, go to next step.
2. Check resistance of Blue instrument cluster connector terminal No. 11 (Black/Orange wire). If resistance is more than 5 ohms, repair open Black/Orange wire. If resistance is less than 5 ohms, replace instrument cluster.