LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Eagle >> 1995 >> Vision ESi >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Computer >> Testing >> Test 59A - Communication With Transmission Control Module
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test 59A - Communication With Transmission Control Module

NOTE: Perform SYMPTOM ID TEST 1B  - IDENTIFYING DIAGNOSTIC TROUBLE CODES or TEST 58A  before proceeding with this test. For connector terminal ID, see CONNECTOR IDENTIFICATION  . For wiring schematics, see WIRING DIAGRAMS  in this article. Perform TEST VER-1 - VERIFICATION PROCEDURE  after each repair.
CAUTION: Always turn ignition off prior to disconnecting any module connector.
  1. Using scan tool, read body computer DTCs. If scan tool displays TRANS PRNDL MESSAGE TEST FAILED, go to step 4). If scan tool does not display TRANS PRNDL MESSAGE TEST FAILED, go to next step.
  2. Using scan tool, actuate PRNDL lamps. If each lamp illuminates individually then all at once, test is successful. Go to next step. If test fails, repair or replace instrument cluster. See appropriate INSTRUMENT PANEL article in the ACCESSORIES & ELECTRICAL section.
  3. Using scan tool, select Transmission Control Module (TCM). Select monitors in state displays. Monitor Shift Lever Position (SLP) state of shift lever status. Apply parking brake. Move gear shift lever through all positions. If SLP state matches gear shift lever position, repair or replace instrument cluster. See appropriate INSTRUMENT PANEL article in the ACCESSORIES & ELECTRICAL section. If SLP state does not match gear shift lever position, see TRANSMISSION ELECTRONIC DIAGNOSIS article in the AUTOMATIC TRANSMISSION section.
    NOTE: Low battery or momentary Chrysler Collision Detection (CCD) bus failure may cause DTCs to set.
  4. Using scan tool, erase DTCs. Start and run engine for 2 minutes. Turn engine off. Turn ignition on. Using scan tool, read body computer DTCs. If TRANS PRNDL MESSAGE TEST FAILED DTC is not present, system is operating properly at this time. If TRANS PRNDL MESSAGE TEST FAILED DTC is present, go to next step.
  5. Turn ignition off. Disconnect Transmission Control Module (TCM) connector. TCM is located in engine compartment between left front fender and battery. Turn ignition on. Using scan tool in voltmeter mode, connect a jumper wire between ground and terminal No. 43 (Violet/Brown wire) on TCM connector. Using scan tool, perform CCD bus test. If scan tool does not display BUS SHORTED TO GROUND, repair open Violet/Brown wire. If scan tool displays BUS SHORTED TO GROUND, go to next step.
  6. Disconnect jumper wire. Connect jumper wire between ground and terminal No. 4 (White/Black wire) TCM connector. If scan tool does not display BUS SHORTED TO GROUND, repair open White/Black wire. If scan tool does not display BUS SHORTED TO GROUND, replace TCM.
scientia non olet · About LEMON Manuals