LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Eagle >> 1995 >> Vision ESi >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 3.3L >> Test TC-26A >> Knock Sensor #2 Circuit (DTC 16)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Knock Sensor #2 Circuit (DTC 16)

NOTE: For connector terminal ID, see CONNECTOR IDENTIFICATION. For wiring diagram, see WIRING DIAGRAMS - 3.3L article in ENGINE PERFORMANCE. After each repair, perform TEST VER-2  .
  1. Using scan tool, erase trouble codes. Test drive vehicle (knock sensor trouble code will only set while vehicle is decelerating). If knock sensor trouble code returns, go to step 5). If knock sensor trouble code does not return, go to next step.
  2. Wiggle knock sensor wiring harness between knock sensor and Powertrain Control Module (PCM). If knock sensor trouble code returns, repair harness between components where wiggling caused trouble code to return. If knock sensor trouble code did not return, go to next step.
  3. At this time, the condition required to set trouble code is not present. KNOCK SENSOR #2 CIRCUIT trouble code sets if knock sensor output falls below a minimum value during deceleration. Knock sensor trouble code also sets if knock sensor output is more than 5 volts. Possible causes are: knock sensor output wire open, knock sensor output wire shorted to ground or voltage, or knock sensor failure.
  4. Inspect wiring and connectors. Repair as required. If wiring and connectors are okay, see INACTIVE TROUBLE CODE CONDITION  . Test is complete.
  5. If knock sensor trouble code returns in step 1), turn ignition off. Disconnect Powertrain Control Module (PCM) connector. PCM is located under air cleaner. Disconnect No. 2 (right) knock sensor connector (Gray/Black wire) at knock sensor common connector. Go to next step.
  6. Using scan tool in ohmmeter mode, check resistance of PCM connector terminal No. 10 (Gray/Black wire). If resistance is less than 5 ohms, repair short to ground in Gray/Black wire. If resistance is more than 5 ohms, go to next step.
  7. Turn ignition on. Using scan tool in voltmeter mode, check voltage on PCM connector terminal No. 10 (Gray/Black wire). If voltage is more than 5 volts, repair short to voltage in Gray/Black wire. If voltage is less than 5 volts, go to next step.
  8. Using an external ohmmeter, check resistance of Gray/Black wire between No. 2 (right) knock sensor connector and PCM connector terminal No. 10. If resistance is less than 5 ohms, replace No. 2 (right) knock sensor. If resistance is more than 5 ohms, repair open Gray/Black wire.
scientia non olet · About LEMON Manuals