LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Eagle >> 1995 >> Vision ESi >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 3.3L >> Test TC-27B >> No Vehicle Speed Sensor Signal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

No Vehicle Speed Sensor Signal

NOTE: For connector terminal ID, see CONNECTOR IDENTIFICATION. For wiring diagram, see WIRING DIAGRAMS - 3.3L article in ENGINE PERFORMANCE. After each repair, perform TEST VER-2  .
  1. Using scan tool in ohmmeter mode, check resistance of Powertrain Control Module (PCM) connector terminal No. 47 (White/Orange wire). PCM is located under air cleaner. If resistance is more than 5 ohms, go to step 3). If resistance is less than 5 ohms, go to next step.
  2. Disconnect Speed Proportional Steering (SPS) Module. SPS module is located on end of steering gear. Check resistance of PCM connector terminal No. 47 (White/Orange wire). If resistance is more than 5 ohms, replace SPS module. If resistance is less than 5 ohms, repair short to ground in White/Orange wire.
  3. If resistance is more than 5 ohms in step 1), use an external ohmmeter to check resistance of White/Orange wire between Powertrain Control Module (PCM) connector terminal No. 47 and Transmission Control Module (TCM) connector terminal No. 58. TCM is located in engine compartment between left front fender and battery. If resistance is more than 5 ohms, repair open White/Orange wire. If resistance is less than 5 ohms, replace PCM.
scientia non olet · About LEMON Manuals