LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Eagle >> 1995 >> Vision ESi >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - Body Control Computer >> Self-Diagnostic Tests >> Test 60A - Diagnosing Instrument Cluster Illumination Problem
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test 60A - Diagnosing Instrument Cluster Illumination Problem

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION  . For wiring diagrams, see appropriate article in ENGINE PERFORMANCE:
  1. Using scan tool, read Body Control Module (BCM) DTCs. If scan tool displays PANEL LAMP PWM OUTPUT FAILURE, go to TEST 60B. If scan tool does not display PANEL LAMP PWM OUTPUT FAILURE, go to next step.
  2. Ensure parking lamp switch is in OFF position. If parking lamps illuminate with parking lamp switch in OFF position, go to TEST 60C  . If parking lamps do not illuminate, go to next step.
  3. Turn parking lamps on. If parking lamps do not illuminate, go to TEST 61A  . If parking lamps illuminate, go to next step.
  4. Move dimmer switch to high. If both turn signal indicators and high beam indicator do not illuminate with parking lights on, go to step 6). If both turn signal indicators and high beam indicator do not illuminate with parking lights on, go to next step.
  5. Turn parking lamps off. Ensure ignition switch is in OFF position. Disconnect instrument cluster connectors. Using scan tool in ohmmeter mode, check resistance of instrument cluster Gray connector terminal No. 3 (Black wire). If resistance is more than 5 ohms, repair open Black wire. If resistance is less than 5 ohms, repair or replace instrument cluster. See appropriate INSTRUMENT PANELS article in ACCESSORIES & EQUIPMENT.
  6. Using scan tool, read panel lamp sensor voltage. Rotate dimmer switch to low then high. If voltage changes evenly between 10 and zero volts, go to TEST 62A  . If voltage does not change evenly between 10 and zero volts, and scan tool displays 0.0 VOLT, go to TEST 63A  . If scan tool does not displays 0.0 VOLT, and panel lamps illuminate properly, system is operating properly at this time. If panel lamps do not illuminate properly, go to next step.
  7. Disconnect headlamp switch connector. Disconnect Body Control Module (BCM) connectors. BCM is located behind right kick panel. Turn ignition on. Using scan tool in voltmeter mode, check voltage on BCM Bone connector terminal No. 4 (Orange/Dark Blue wire). If voltage is more than 10 volts, repair short to battery voltage in Orange/Dark Blue wire. If voltage is less than 10 volts, replace BCM.
scientia non olet · About LEMON Manuals