Test TC-113B - EVAP Purge Flow Monitor Failure
NOTE:
For connector terminal ID, see CONNECTOR IDENTIFICATION Directory. For wiring diagram, see WIRING DIAGRAMS
article.
- Disconnect purge vacuum hose at canister. Attempt to blow air through vacuum line that goes to canister. If vacuum line allows air to pass, go to next step. If vacuum line does not allow air to pass, repair or replace vacuum line as necessary. Perform TEST VER-2A.
- Check for plugged vent port on canister. If vent port is plugged, repair plugged vent port and retest. Perform TEST VER-2A. If vent port is not plugged, replace evap canister. Perform TEST VER-2A.