Test 86A - Testing OTIS Switches
NOTE:
For connector terminal identification and wiring diagrams, see BODY CONTROL COMPUTER
section in this article. Perform TEST VER-1
VERIFICATION TEST after each repair.
CAUTION:
Always turn ignition off prior to disconnecting any module connector.
- Turn ignition off. Leave key in ignition switch. Open left front door. If chime does not sound, go to TEST 1. If chime sounds, go to next step.
- Turn ignition on. Close left front door. Press each OTIS button and listen for beep. If beep is not heard, replace OTIS module. If beep is heard, switches are working properly at this time.