Test TC-35C - No Vehicle Speed Sensor Signal
NOTE:
For connector terminal ID, see CONNECTOR IDENTIFICATION Directory. For wiring diagram, see appropriate WIRING DIAGRAMS - NON-TURBO
article.
- Turn ignition off. Using scan tool in ohmmeter mode, check resistance on VSS connector ground circuit (Black/Dark Green wire). If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or more, repair open VSS ground circuit. Perform TEST VER-2A.
- Disconnect Powertrain Control Module (PCM) connector. Inspect PCM connector for pushed out or damaged terminals. Repair PCM connector as necessary. Perform TEST VER-2A. If PCM connector is okay, replace PCM. Perform TEST VER-2A.