Diagnostic Procedure
NOTE:
Diagnostic procedures must be performed in proper sequence using the following steps to ensure proper diagnosis.
- Retrieve Diagnostic Trouble Codes (DTCs) from ECM. See RETRIEVING DIAGNOSTIC TROUBLE CODES under SELF-DIAGNOSTIC SYSTEM. Record DTC for future reference.
- Clear DTCs from ECM. See CLEARING DIAGNOSTIC TROUBLE CODES under SELF-DIAGNOSTIC SYSTEM. Road test vehicle using proper vehicle drive cycle. See VEHICLE DRIVE CYCLE under SELF-DIAGNOSTIC SYSTEM.
- Check for a trouble symptom. If trouble symptom, such as stalling or hard starting exists, proceed to trouble symptom inspection table and then perform a specified inspection procedure. Trouble symptom inspection table and trouble symptom inspection procedures are listed after the Diagnostic Trouble Code (DTC) tests. See TROUBLE SYMPTOMS .
- If no trouble symptom exists, retrieve DTCs from ECM. Using all DTCs obtained, proceed to SELF-DIAGNOSTIC TESTS . Once all repairs are made, ensure DTCs are cleared from PCM. See procedures under CLEARING DIAGNOSTIC TROUBLE CODES . Repeat vehicle drive cycle to ensure repair complete and DTC is not reset. See VEHICLE DRIVE CYCLE under SELF-DIAGNOSTIC SYSTEM.