LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Eagle >> 1998 >> Talon Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Self-Diagnostics - With Codes >> DTC Test >> Test TC-102A: O2 Sensor 1/1 Slow Response
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test TC-102A: O2 Sensor 1/1 Slow Response

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION . For wiring diagram, see WIRING DIAGRAMS article.
  1. For O2 sensor/model identification see O2 SENSOR 1/1 IDENTIFICATION  table. O2 SENSOR 1/1 SLOW RESPONSE DTC sets if upstream O2S 1/1 signal voltage is switching from less than .39 volt to more than .6 volt and back fewer times than required. Possible causes are: exhaust leak, fuel contamination, dirty or wet O2 sensor connector causing voltage tracking or engine mechanical failure. Go to next step.
    O2 SENSOR 1/1 IDENTIFICATION

    Application Location
    Avenger, Sebring Coupe & Talon
    4-Cylinder Upstream O2S
    V6 Rear Bank Upstream O2S
    Breeze, Cirrus, Neon, Sebring Conv. & Stratus
    4-Cylinder Upstream O2S
    V6 Upstream O2S
  2. Start engine. Check for exhaust system leaks between engine and catalytic converter. If no exhaust system leaks are found, go to next step. If exhaust system leaks are found, repair exhaust system as necessary. Perform TEST VER-5A .
  3. Check exhaust for excessive smoke from coolant or oil consumption. If coolant or oil consumption is not present, go to next step. If coolant or oil consumption is present, repair engine mechanical failure as necessary. Replace O2S 1/1. Perform TEST VER-5A .
  4. Turn ignition off. Disconnect O2S 1/1 connector. Using an ohmmeter, check resistance of sensor ground circuit between O2S 1/1 connector (harness side) and ground. See O2S 1/1 CONNECTOR WIRE IDENTIFICATION (HARNESS SIDE)  table. If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or more, repair open sensor ground circuit. Perform TEST VER-5A .
  5. Disconnect Powertrain Control Module (PCM) connector. Inspect PCM connector. If condition of PCM connector is okay, replace O2S 1/1. Perform TEST VER-5A . If condition of PCM connector is not okay, repair as necessary. Perform TEST VER-5A .
O2S 1/1 CONNECTOR WIRE IDENTIFICATION (HARNESS SIDE)

Application Wire Color
O2S 1/1 Sensor Signal Circuit
Avenger, Sebring Coupe & Talon White/Black
Breeze, Cirrus, Neon, Sebring Conv. & Stratus Black/Dark Green
O2S 1/1 Sensor Ground Circuit
Avenger, Sebring Coupe & Talon Black/Dark Green
Breeze, Cirrus, Neon, Sebring Conv. & Stratus Black/Light Blue
scientia non olet · About LEMON Manuals