Test TC-113F: EVAP Purge Flow Monitor Failure
NOTE:
This procedure applies only to Neon. EVAP system is located near fuel tank.
- Remove EVAP purge solenoid. Tap solenoid ports against a clean surface. If any foreign material falls out, go to next step. If foreign material did not fall out, replace EVAP purge solenoid. Perform TEST VER-2A .
- Inspect vacuum line from proportional purge solenoid to canister. If vacuum line is damaged, replace vacuum line and replace EVAP purge solenoid. Perform TEST VER-2A . If vacuum line is not damaged, clean out line and replace EVAP purge solenoid and canister. Perform TEST VER-2A .