A/C And Heater Control Module - Removal

REMOVAL

NOTE: Air inlet housing removed from view for clarity.





1. Disconnect and isolate the negative battery cable.
2. Remove the glove box Instrument Panel Glove Box - Removal.
3. Disconnect the wire harness connector (4) from the A/C heater module (2), located on the right side of the HVAC housing (5).

NOTE: Use a flexible drive socket to remove the lower module retaining screw (3).

4. Remove the three screws (1 and 3) that secure the A/C heater module to the housing and remove the module.