Module, Fuel Pump: Removal: Removal

Fig 1: Seat Cushion, Mounting Bolts & Access Cover

Courtesy of CHRYSLER GROUP, LLC

WARNING:

The fuel system may be under a constant pressure (even with the engine off). Before servicing the fuel pump module, the fuel system pressure must be released.

Perform the fuel pressure release procedure. Refer to FUEL SYSTEM PRESSURE RELEASE . .
Disconnect and isolate the negative battery cable.
Remove the rear lower seat mounting bolts (3).
Carefully remove the cushion (1) assembly past the seat belt latches.
Locate the fuel pump module access cover (2).

Fig 2: Access Cover, Connector & Screws
Courtesy of CHRYSLER GROUP, LLC
Remove the fuel pump module access cover (1) by removing the screws (2).
Disconnect the fuel pump module wiring connector (4).

Fig 3: Fuel Supply, Return & Vapor Lines
Courtesy of CHRYSLER GROUP, LLC
Disconnect the fuel lines. Refer to STANDARD PROCEDURE - QUICK-CONNECT FITTINGS . .

Fig 4: Fuel Pump Module, Locking Ring & Lock Ring Wrench
Courtesy of CHRYSLER GROUP, LLC
Remove the fuel pump module locking ring (3) using SAE Fuel Pump Lock Ring Wrench (special tool #9340, SAE Fuel Pump Lock Ring Wrench) (2).
Remove the fuel pump module (4) from the fuel tank and discard the seal (gasket).