Blower Motor Power Module - Installation

INSTALLATION





1. Install the blower motor power module (4) to the right side of the HVAC housing (2) and install the two retaining screws (1 and 3). Tighten the screws to 0.8 Nm (7 in. lbs.).
2. Connect the three wire harness connectors (5) to the blower motor power module.
3. Install the recirculation door actuator Recirculation Door Actuator - Installation.





4. Position the passenger side console closeout cover (1) and engage the front retaining tab.
5. Carefully engage the console closeout cover rear retaining clips and install the screw (2). Tighten the screw securely.
6. Install the passenger side silencer panel Silencer Panel - Installation.
7. Reconnect the negative battery cable.