LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 1990 >> Bronco II RWD, Standard, M5OD-R1 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests >> Idle Control System >> ISC Motor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

ISC Motor

  1. Turn key off and wait 10 seconds. Disconnect ISC motor connector. Using DVOM, touch positive lead on ISC connector VPWR terminal and negative lead on ISC terminal. See ISC MOTOR RESISTANCE  . If resistance is not within specification, replace ISC motor. If resistance is correct, proceed to step 2.
  2. Measure resistance between either ISC connector terminal and ISC housing. Resistance should be more than 10 k/ohms. If resistance is not more than 10 k/ohms, replace ISC motor. If resistance is more than 10 k/ohms, go to step 3.
  3. Turn ignition on. Using a voltmeter, measure voltage between ISC motor harness connector terminals. If voltage is less than 2.0 volts, repair open circuit and repeat test. If voltage is greater than 5.5 volts, turn ignition off. With ISC connector disengaged, connect Breakout Box (014-00322) and leave processor disconnected.
  4. Measure resistance between breakout box test pin No. 21 and ISC terminal on ISC connector. If resistance is greater than 5 ohms, repair open circuit and repeat test. If resistance is less than 5 ohms, measure resistance between breakout box test pin No. 21 and following test pins: No. 40, No. 46 and No. 60. If resistance is less than 10 k/ohms, repair short circuit and repeat test.
ISC MOTOR RESISTANCE

Application Specification
"F" Series with 5.0L 17-21 ohms
All Other Models 9.5-11.5 ohms
scientia non olet · About LEMON Manuals