ISC Motor (CFI)
- Turn key off and wait 10 seconds. Disconnect harness from DC motor. Using jumper wires, connect ISC positive (+) circuit of DC motor to battery positive (+) terminal. Connect ISC negative (-) circuit of DC motor to battery negative terminal for 4 seconds.
- Motor shaft should extend more than 2" (51 mm). Connect ISC (+) circuit of DC motor to battery negative terminal and ISC (-) circuit of DC motor to battery positive terminal for 4 seconds. Motor shaft should retract to less than 1 3/4" (44 mm). If motor shaft does not move in and out as indicated, replace DC motor.