Ignition Control Module: Service and Repair

REMOVAL

1. Remove distributor cap and position it and attached wires aside so as not to interfere with work area.
2. Remove TFI-IV harness connector.
3. Remove distributor from engine.
4. Remove TFI-IV module attachment screws.
5. Pull RH side of module down distributor mounting flange and back up to disengage module terminals from connector in distributor base. The module may be pulled toward flange and away from distributor.

INSTALLATION

1. Apply a 1/32 inch coating of silicone grease to metal base of module. Position module on distributor mounting flange.
2. Carefully position module toward distributor bowl and securely engage the 3 distributor connector pins.
3. Install 2 module attaching screws and adjust to specification. Install distributor.