LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 1991 >> Explorer 2D Utility, 4WD, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests >> Electronic Control Assembly (ECA) >> Power Circuits
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Power Circuits

Using a voltmeter, check for battery voltage between ECA terminal No. 1 (KAPWR) and ground. Check for battery voltage at terminals No. 37 and 57 (VPWR). If battery voltage is not present, power is not being supplied from EEC power relay. See CIRCUIT TEST B in TESTS W/CODES EEC-IV article in the ENGINE PERFORMANCE Section.

ECA LOCATION (1)

Application Location
Aerostar Left Firewall, Left of Master Cylinder
Bronco & "F" Series Left Firewall, Below Brake Fluid Reservoir
Explorer, Navajo & Ranger Behind Right Kick Panel
"E" Series Right Fender Apron, Under Blower Motor
(1) See Fig 2-5 for ECA location diagrams (except Bronco and Pickup).
Fig 1: 60-Pin Connector Terminal ID
G92G21937Courtesy of FORD MOTOR CO.
Fig 2: ECA Location (Aerostar)
G92H21938Courtesy of FORD MOTOR CO.
Fig 3: ECA Location (Van)
G92I21939Courtesy of FORD MOTOR CO.
Fig 4: ECA Location (Explorer)
G92B21940Courtesy of FORD MOTOR CO.
Fig 5: ECA Location (Ranger)
G92C21941Courtesy of FORD MOTOR CO.