LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 1992 >> Explorer 2D Utility, RWD, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests - Gasoline >> Dis System >> Pinpoint Test C
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Pinpoint Test C

  1. Check For Left Side Spark With KOER  Start engine and using spark tester, check for spark at each left spark plug wire. If spark is present at any left spark plug wire, go to step 2). If spark is not present, go to PINPOINT TEST D, Step 1).
  2. Check IDM With KOER  With ignition off, install DIS diagnostic cable module tee (pins No. 7-12) to DIS module. Connect DIS diagnostic cable to BOB. Use 2.3L DP DIS overlay. Connect LED test light positive lead to IDM (J4) and negative lead to BAT - (J60). Start engine and observe test light. If test light blinks continuously, go to step 3). If test light does not blink, go to step 4).
  3. Check IDM To ECA Continuity To ECA  With ignition off, disconnect ECA. Crank engine and observe test light. If test light blinks continuously, replace ECA. ECA does not respond to IDM input. Remove test equipment and reconnect all components. Clear Continuous Memory Codes and rerun Quick Test. If test light does not blink, go to step 4).
  4. Isolate ECA & Check IDM Circuit During Cranking  With ignition off, disconnect ECA. Crank engine and observe test light. If test light blinks continuously, replace ECA, the ECA is shorting IDM circuit. If test light does not blink, go to step 5).
  5. Check IDM For Short To Power  With ignition off, and disconnect HEGO sensor. Disconnect DIS diagnostic cable module tee (pins No. 7-12) from DIS module. Set DVOM on 20 k/ohm scale. Measure resistance between IDM (J4) and VBAT D (J5). If resistance is less than 10 k/ohms, check connectors and service or replace harness. IDM is shorted to VBAT. Remove test equipment and reconnect all components. Clear Continuous Memory Codes and rerun Quick Test. If resistance is 10 k/ohms or more, go to step 6).
  6. Check IDM For Short To Ground  With ignition off, disconnect diagnostic cable connector from DIS module (pins No. 7-12). Set DVOM on 20 k/ohm scale. Measure resistance between IDM (J4) and BAT - (J60). If resistance is 10 k/ohm or less, check connectors and service or replace harness. IDM is shorted to ground. Remove test equipment and reconnect all components. Clear Continuous Memory Codes and rerun Quick Test. If resistance is 10 k/ohm or more, replace DIS module. IDM is shorted in DIS module. Remove test equipment and reconnect all components. Clear Continuous Memory Codes and rerun Quick Test.
scientia non olet · About LEMON Manuals