Wheel Speed Sensor Signal Check
- Ensure ignition is off. Disconnect ABS control module connector. See Figure
. Set VOM on 5-volt scale. While rotating each wheel at 60 RPM, measure and record voltage at each of following wires at control module connector:
- White and Red wires (Left Front Wheel Speed Sensor).
- Yellow and Orange wires (Right Front Wheel Speed Sensor).
- Red and Yellow/Black wires (Left Rear Wheel Speed Sensor).
- Green/Black wires (Right Rear Wheel Speed Sensor).
- If ALL voltage readings are .25-3.0 volts, go to PINPOINT TEST WSS-7 . If any voltage reading is not with specification, go to PINPOINT TEST WSS-6 .