LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 1993 >> Probe Base, Standard >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Keyless Entry System - Remote >> Testing >> Test Re >> Re13
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test Re: Re13

  1. Ensure ignition switch is in OFF position. Disconnect control module connectors No. 1 and 2. Check resistance in Blue/Green wire between control module connector No. 1 and program connector. Check resistance in Blue/White wire between connector No. 2 and program connector. Resistance should be less than 5 ohms. If resistance is not as specified, repair wire in question.
  2. Check resistance in Blue/Green wire between control module connector No. 1 and chassis ground. Check resistance in Blue/White wire between control module connector No. 2 and chassis ground. Resistance should be greater than 10,000 ohms. If resistance is not as specified, repair wire in question.
  3. Check resistance between Blue/Green wire and Blue/White wire at program connector. See Figure . Resistance should be greater than 10,000 ohms. If resistance is not as specified, repair wire in question.
  4. If resistance is as specified, but system cannot be programmed, go to RE14. If resistance is as specified, but doors lock when ignition switch is in ON position, replace control module.
scientia non olet · About LEMON Manuals