Main Switch Test
With ignition off, remove main power window switch. Leave electrical connector connected. Check voltage at switch as shown in the MAIN POWER SWITCH VOLTAGES table, while altering switch positions. If voltages are within specification, go to appropriate test under TROUBLE SHOOTING, if applicable. If voltages are not within specification, replace main power window switch.
MAIN POWER SWITCH VOLTAGES
| Switch Position & Wire Color | (1) Volts | |||
|---|---|---|---|---|
| Left Up | ||||
| GRN/BLU | 12 | |||
| RED/BLU | 0 | |||
| GRN/WHT | 0 | |||
| RED/WHT | 0 | |||
| Left Down | ||||
| GRN/BLU | 0 | |||
| RED/BLU | 12 | |||
| GRN/WHT | 0 | |||
| RED/WHT | 0 | |||
| Left One-Touch | ||||
| GRN/BLU | 0 | |||
| RED/BLU | 12 | |||
| GRN/WHT | 0 | |||
| RED/WHT | 0 | |||
| Right Up | ||||
| GRN/BLU | 0 | |||
| RED/BLU | 0 | |||
| GRN/WHT | 12 | |||
| RED/WHT | 0 | |||
| Right Down | ||||
| GRN/BLU | 0 | |||
| RED/BLU | 0 | |||
| GRN/WHT | 0 | |||
| RED/WHT | 12 | |||
| Right One-Touch | ||||
| GRN/BLU | 0 | |||
| RED/BLU | 0 | |||
| GRN/WHT | 0 | |||
| RED/WHT | 12 | |||
|
||||