Control Unit Connector Resistance Check
- Turn ignition off. Verify ABS control unit connector is disconnected. Set DVOM on 2-k/ohm scale. Measure and record resistance between each of following ABS connector wire terminals. See PINPOINT TEST WSS-3 CIRCUIT IDENTIFICATION table.
- If ALL resistances are between 1600-2000 ohms, go to PINPOINT TEST WSS-5 . If any resistance is not within specification, go to PINPOINT TEST WSS-4 .
PINPOINT TEST WSS-3 CIRCUIT IDENTIFICATION
| Wire Color | Application | |
|---|---|---|
| Escort & Tracer | ||
| Black/White & Orange/White | LF Wheel Speed Sensor | |
| Black/Red & Orange | RF Wheel Speed Sensor | |
| Black/Blue & Red/Blue | LR Wheel Speed Sensor | |
| Black/Orange & White | RR Wheel Speed Sensor | |
| Probe | ||
| White & Red | LF Wheel Speed Sensor | |
| Yellow & Orange | RF Wheel Speed Sensor | |
| Yellow/Green & Yellow/Blue | LR Wheel Speed Sensor | |
| Green & Blue | RR Wheel Speed Sensor | |