Remote Transmitter
NOTE:
For additional information on remote transmitter programming and trouble shooting, see REMOTE KEYLESS ENTRY DIAGNOSTIC SERVICE TIPS
bulletin (Ford Bulletin No. 97-24-13) in TSB.
To program (or re-program) transmitter(s) into the remote/keyless entry module, perform the following steps:
- Turn ignition to RUN or ACC position. Remove right quarter panel interior trim panel. Remove sub-woofer speaker (if equipped). Locate program connector. Using a jumper wire, momentarily short the terminals of the programming connector located in right rear quarter panel area. See Fig 1 . All doors should lock then unlock to confirm programming mode has been entered.
- Press any button on transmitter. All doors should lock then unlock, to verify that transmitter has been programmed.
- Repeat step 2 for additional remote transmitters (up to 4 maximum). Turn ignition OFF. All doors should lock then unlock to confirm end of programming mode. Check operation of remote transmitters.
NOTE:
If doors do not respond, press button again (3 times maximum) with same transmitter. If doors still won't lock, go to TROUBLE SHOOTING
.