Camber Adjustment (Front)
- Top mounting studs on front struts are offset. Camber is adjusted by rotating strut to different positions. Refer to the CAMBER/CASTER SPECIFICATIONS
table. Lift vehicle to unload suspension.
- Remove wheel. Remove top strut attaching nuts. Lower strut, and rotate strut bearing to desired position. See Fig 1
. Reinstall strut into tower. Install and tighten attaching nuts.
Courtesy of FORD MOTOR CO. CAMBER/CASTER SPECIFICATIONS
| Mark |
Camber Angle (Degrees) |
Caster Angle (Degrees) |
| "A" |
0 |
.5 |
| "B" |
.5 |
.5 |
| "C" |
.5 |
0 |