Power Window Motor: Installation
- To install, reverse removal procedure. Tighten retaining screws to 53-80 INCH lbs. (6-9 N.m). Remove prop holding window glass up. Install 2 pieces of waterproof pressure sensitive tape over drilled holes.
- Reconnect window motor connector. Reconnect negative battery cable. Test window operation. Ensure door drain holes are open and reinstall door trim panel.
- To install, reverse removal procedure. Tighten retaining screws to 53-80 INCH lbs. (6-9 N.m). Remove prop holding window glass up. Install waterproof pressure sensitive tape over drilled hole.
- Reconnect window motor connector. Reconnect negative battery cable. Test window operation. Ensure door drain holes are open and reinstall door trim panel.