LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 1997 >> Mustang Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Module Communications Network System >> Communication Network Diagnostics >> Diagnostic Command
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Command

NOTE: This procedure may be used to verify operation of output circuitry for selected module being tested.
  1. Connect New Generation Star (NGS) scan tester on Data Link Connector (DLC) and perform proper hook-up procedure. See EQUIPMENT HOOK-UP .
    NOTE: If instructed to retrieve PID from a specified test procedure, ensure ignition is in proper position as listed in test procedure or the test will fail.
  2. Turn ignition switch to RUN position unless otherwise instructed by specified test procedure. Rotate dial on scan tester to DIAGNOSTIC DATA LINK menu and press trigger.
  3. Rotate dial on scan tester to highlight the desired module you wish to access and press trigger. Rotate dial on scan tester to highlight ACTIVE/COMMAND MODES and press trigger.
  4. Rotate dial on scan tester to selected command and press trigger.
scientia non olet · About LEMON Manuals