Remote Transmitter
WARNING: This page is about a different car, the 1997 Lincoln Mark VIII. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For additional information on remote transmitter programming and trouble shooting, see REMOTE KEYLESS ENTRY DIAGNOSTIC SERVICE TIPS
bulletin (Ford Bulletin No. 97-24-13) in TSB.
To program (or re-program) transmitter(s) into the remote/keyless entry module, perform the following steps:
- Enter 5-digit permanent entry code into keyless entry keypad. Within 5 seconds of pressing last digit of permanent entry code, press 1/2 button on keypad. All doors should lock and unlock to confirm programming mode has been entered. Press ANY button on remote transmitter within 5 seconds of pressing 1/2 button. All door locks will cycle to indicate successful programming of transmitter.
- If additional transmitters are to be programmed, press any button on next transmitter to be programmed within 5 seconds of programming first transmitter. If programming is successful, doors will signal by locking and unlocking.
- If keypad light goes out before all transmitters are programmed, repeat process from step 1) . Up to 4 transmitters may be programmed for a vehicle. Press 7/8 and 9/0 buttons simultaneously on keypad to exit program mode.
NOTE:
The remote/keyless entry module erases all previous transmitters from memory when the transmitters are programmed or re-programmed. The remote/keyless entry module can store up to four transmitters in memory.