LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 1997 >> Probe Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Module Communications Network) >> Communication Network Diagnostics >> Data Link Diagnostics
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Data Link Diagnostics

WARNING: This page is about a different car, the 1997 Lincoln Continental. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect New Generation Star (NGS) scan tester on Data Link Connector (DLC) and perform proper hook-up procedure. See EQUIPMENT HOOK-UP under COMMUNICATION NETWORK DIAGNOSTICS  .
    NOTE: Ensure ignition switch is in ON position when performing this procedure or procedure will fail.
  2. Turn ignition switch to ON position. Rotate dial on scan tester to menu item DIAGNOSTIC DATA LINK and press trigger. A test will be performed on the BUS (circuits No. 914 and 915) for the module communications network and the ISO 9141 communication link circuit No. 70. This is the Light Blue/White wire that goes between terminal No. 7 on DLC and the air bag diagnostic monitor.
  3. If scan tester displays CKT 914 (+) = SYSTEM PASSED and CKT 915 (-) = SYSTEM PASSED, module communications network is okay. If scan tester displays CKT 70 = SYSTEM PASSED, ISO 9141 communication link is operating properly.
  4. If scan tester does not display CKT 914 (+) = SYSTEM PASSED, CKT 915 (-) = SYSTEM PASSED and CKT 70 = SYSTEM PASSED, proceed testing for module communication network failure. See COMMUNICATION NETWORK FAILURE under TESTING  .
scientia non olet · About LEMON Manuals