LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 1999 >> Contour SVT >> Repair and Diagnosis >> General Information >> Computer Relearn Procedures >> Computer Relearn Procedures >> Continental >> Keypad Programming
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Keypad Programming

  1. Enter 5-digit permanent entry code at keypad. Within 5 seconds of pressing last digit, press 1/2 button on keypad to activate programming mode. Hold 1/2 button for more than 2 seconds to erase all stored customer codes. Door locks will lock and unlock to confirm all codes are erased. Existing codes do not need to be erased to program new codes.
  2. Enter new 5-digit keypad code. To associate new code with personality position No. 1 or 2, within 7.5 seconds of entering last digit of new code, press 1/2 button for position No. 1 or 3/4 button for position No. 2. Doors will lock and unlock to confirm new code is programmed. If another code is to be programmed, begin entering code within 7.5 seconds of pressing last button.
    CUSTOMER PREFERENCE INDEX (CONTINENTAL)

    Module Configurable Item State
    Driver's Door Module Remote Transmitter Programming ID Code (TIC) Value
    Lighting Control Module Headlights On With Wipers Enabled, Disabled
    Lighting Control Module Daytime Running Lights Enabled, Disabled
    Lighting Control Module Bulb Out Strategy Enabled, Disabled
    Remote Emergency Satellite Cellular Unit Module Vehicle Identification Number (VIN) Download Enter VIN
    Restraint Control Module Side Air Bags With Or Without
    Instrument Cluster Enter Security Access Enter Security Access
    Instrument Cluster Ignition Key Code Program Program Ignition Keys
    Instrument Cluster Ignition Key Code Erase Erase All Stored Ignition Keys
    Instrument Cluster Spare Key Enabled, Disabled
    Instrument Cluster Parameter Reset Reset Security
  3. After all new codes are programmed, a new remote transmitter can be programmed within 7.5 seconds of pressing last digit in keypad code. To exit program mode, press keyless entry keypad buttons 7/8 and 9/0 at the same time or wait 7.5 seconds for DDM to exit automatically.
NOTE: This procedure is used when a customer needs keys programmed into system and does not have 2 programmed ignition keys available, or when programmed ignition keys have been lost and/or ignition switch assembly has been replaced. This procedure will erase all programmed ignition keys from memory and prevent vehicle from starting until 2 keys have been programmed. Ignition keys must have correct mechanical key cut for vehicle and must be an encoded key. If additional key(s) are to be programmed, perform KEY PROGRAMMING - USING 2 PROGRAMMED KEYS. If remaining keys are with customer and not with vehicle, instruct customer to see owner's manual to program spare key(s).
scientia non olet · About LEMON Manuals