Remote Transmitter
- iver's window. Turn ignition switch to RUN or ACC position. Access programming connector. Programming connector is behind left trunk trim panel, attached to relay panel. Using jumper wire, momentarily short the 2 terminals of programming connector together. Both doors should lock then unlock to confirm program mode has been entered.
- Press any button on keyless entry remote transmitter. Both doors should lock then unlock to confirm that transmitter has been programmed.
- Repeat step 2) to program all other transmitter (maximum of 4 transmitters) to be used with this system before exiting programming. To exit programming, turn ignition switch to LOCK position. To confirm programming mode has been exited, both doors should lock then unlock.