LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2000 >> Contour SVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Computer Relearn Procedures) >> Computer Relearn Procedures >> Continental >> Virtual Instrument Cluster (VIC) Programming
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Virtual Instrument Cluster (VIC) Programming

WARNING: This page does not describe the selected car, but rather 26 other vehicles, including the 1999 Mercury Villager, 1999 Mercury Tracer, 1999 Mercury Sable, 1999 Mercury Mystique, and 1999 Mercury Mountaineer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch to LOCK position. Using NGS tester, retrieve and record continuous DTCs. Clear continuous DTCs and perform instrument cluster self-test. If DTC B2139 is retrieved, go to next step. If DTC B2139 is not retrieved, system is okay at this time.
  2. Perform security access for instrument cluster. See KEY PROGRAMMING - SECURITY ACCESS PROCEDURE. Using NGS tester, select PARAMETER RESET command for instrument cluster. Using NGS tester, select PARAMETER RESET command for PCM. Turn ignition switch to RUN position for 30 seconds. Turn ignition switch to LOCK position. Using NGS tester, perform instrument cluster self-test. If DTC B2139 is not retrieved, system is okay at this time. If DTC B2139 is retrieved, verify PCM calibration is correct for vehicle. If calibration is okay, replace instrument cluster. If DTC B2139 still exists, replace PCM.
scientia non olet · About LEMON Manuals