Town Car
- Cycle ignition switch from LOCK to RUN positions 4 times within 3 seconds. Locks will lock and unlock to confirm programming mode has been entered. Press any button on remote transmitter.
- If additional remote transmitters are to be programmed, press any button on remaining remote transmitters within 7.5 seconds. To exit programming mode, turn ignition switch to START position or wait 7.5 seconds.
- To set a remote transmitter to also operate a memory set position, press SET button on memory switch then press any button on remote transmitter then press appropriate memory button (1 or 2). To clear a memory set position from a transmitter, repeat this step.
NOTE:
After first remote transmitter is programmed, all other remote transmitters will be erased from memory. All remote transmitters must be programmed at the same time. Up to 4 transmitters may be programmed at one time.