Remote Keyless Entry (RKE) Transmitter Programming: Focus
Turn ignition switch to accessory position. When clock LED illuminates, turn ignition off and remove key. Press and hold either button on remote transmitter until LED on remote transmitter flashes 5 times. While still holding button down, press other button 3 times. Release both buttons. To program additional transmitters, repeat button pressing for each transmitter. To exit learning mode, turn ignition switch to RUN position then to OFF position. After 20 seconds, system will exit learning mode. Check all transmitters.
NOTE:
After first remote transmitter is programmed, all other remote transmitters will be erased from memory. All remote transmitters must be programmed at the same time.