Module Configuration

NOTE: Powertrain Control Module (PCM) has to be flash programmed using a flash cable. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION. The Integrated Circuit (IC) is reprogrammable, and at times it may become necessary to reprogram or reflash entire contents. This procedure can only be performed using Ford's Service Bay Technical System (SBTS) or equivalent.

NOTE: Newly released modules will require configuration after being installed on vehicle. All configurable modules will be packaged in a kit which contains a warning label and multi-language sheet reemphasizing requirements to configure replacement modules. A New Generation Star (NGS) tester or Ford compatible scan tool MUST be used to retrieve configuration data from old module before it is removed from vehicle. This information will be transferred into new module so that new module will contain same settings as old module. NGS tester will not retain stored configuration information for longer than 24 hours.

Following manufacturer's instructions, upload old information from old module using Ford Service Function (FSF) card and NGS tester. Install new module and download stored information into new module using FSF card and NGS tester.