Pressure Bleeding

Clean reservoir cap area. Connect pressure bleeder. Remove dust cap from right rear wheel bleeder screw. Attach hose to bleeder screw. Submerge other end of hose in container of clean brake fluid.
Open valve on bleeder tank to pressurize system. Maintain system pressure at less than 50 psi (3.5 kg/cm² ). With brake pedal released, open bleeder screw until air bubbles no longer emerge from submerged end of hose.
Repeat procedure at left rear, right front and left front wheels. When complete, close pressure bleeder tank valve. Remove adapter and adjust fluid level to .16" (4.1 mm) below MAX line. Tighten bleeder screws to specification. See TORQUE SPECIFICATIONS .

NOTE: Engine must be running to provide adequate voltage to ABS control module during anti-lock control portion of following service bleed procedure. Ensure brake fluid reservoir level remains constant during bleeding procedure.