LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2000 >> ZX2 Automatic >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Control System >> Diagnosis & Testing >> System Pre-Check
April 5, 2026: LEMON Manuals is launched! Read the announcement.

System Pre-Check

  1. While observing ABS warning indicator, turn ignition on. If indicator illuminated for about 2 seconds or stays illuminated, go to step 3)  . If ABS indicator did not illuminate, go to next step.
  2. Turn ignition off. Install Breakout Box (014-00322) with ABS Adapter Cable (007-000103) to Control Module. Connect a jumper wire between Breakout Box pins No. 33 and 60. Turn ignition on, for 10 seconds. Turn ignition off. If ABS warning light is illuminated, replace ABS control module and go to next step. If ABS warning light does not illuminate, see appropriate INSTRUMENT PANELS article in ACCESSORIES & EQUIPMENT.
  3. Check condition and resistance of AIR COND (15-amp) fuse in fuse panel. Connect NGS tester or scan tool. Turn ignition on. Retrieve and document continuous DTCs. See RETRIEVING DIAGNOSTIC TROUBLE CODES  . If DTCs exist, record all DTCs in order. Starting with first DTC recorded, go to DIAGNOSTIC TROUBLE CODE DEFINITIONS  table under DIAGNOSIS & TESTING.
  4. If SYSTEM PASS and no DTCs were recorded, perform DRIVE CYCLE TEST  . If SYSTEM PASS was obtained, but concern still exists, see INTERMITTENT FAILURES  . If no response is obtained, go to TEST R  .
scientia non olet · About LEMON Manuals