Steering Column Lock Actuator Module Parameter Reset (LS - Manual Transmission Only)
WARNING: This page does not describe the selected car, but rather 98 other vehicles, including the 2001 Saturn SW2, 2001 Saturn SL2, 2001 Saturn SL1, 2001 Saturn SL, and 2001 Saturn SC2. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Steering Column Lock (SCL) actuator will only allow communication with NGS tester after SCL has been activated. SCL can be activated 2 ways: open driver's door and DO NOT put key in ignition lock cylinder, or press a single button on key fob with ignition key removed from ignition lock cylinder. SCL actuator will stay activated for 30 minutes and reset procedure.
Remove ignition key from ignition lock cylinder. Close and open driver's door. Connect NGS tester and use service function card. Select SCLM, then ENTER SECURITY ACCESS. Wait 8 minutes for security access to be granted. Select PARAMETER RESET. Insert ignition key into ignition lock cylinder and turn ignition switch to RUN position. Select ICM, then select ENTER SECURITY ACCESS. Wait 10 minutes for security access to be granted. Select RESET SCLM PARAMETER. Disconnect NGS tester. Turn ignition switch to OFF position. Remove ignition key from ignition lock cylinder. Insert ignition key into ignition lock cylinder. Turn ignition switch to RUN position. Turn ignition switch to OFF position and remove ignition key from ignition lock cylinder.