Input Shaft: Assembly

WARNING: This page is about a different car, the 2003 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.

Carefully clean and check all parts and coat with manual transmission fluid before reassembly.
Using a press and a suitable tube, install the bearing (clutch end).

Fig 1: Installing Bearing (Clutch End)
Courtesy of FORD MOTOR CO.

NOTE: The annular groove in the bearing must face outwards.

Fig 2: Installing Bearing (Transaxle End)

Courtesy of FORD MOTOR CO.

Using a press and a suitable tube, install the bearing (transaxle end).