Shift Interlock & Ignition Relay: Notes

NOTE: Component testing procedures are provided to determine whether a component is good or bad. Testing information for each component includes a schematic, a view of the terminal locations and step-by-step test procedures. Terminal locations are identified by numbers or letters that may be on the component or next to it. The component connector must be removed before testing. To test a single circuit within the component, select that circuit under the column "Circuit To Test". If you wish to test the complete component, perform all tests. Connect the tester to the terminals shown in the 2nd column, and check the operation of the component using the results in the 3rd column.

NOTE: For circuit reference, see CONNECTOR IDENTIFICATION and WIRING DIAGRAMS . For identification of circuits related to this system, but not shown, see POWER DISTRIBUTION article in WIRING DIAGRAMS.