Key Programming - With Programmed Keys
NOTE:
This procedure will only work if 2 or more programmed ignition keys are available and there is a need to program additional keys. If 2 keys are not available, perform KEY PROGRAMMING - WITHOUT PROGRAMMED KEYS
. PID SPARE_KY must be enabled for this procedure to operate. To enable this PID, perform KEY PROGRAMMING - SECURITY ACCESS PROCEDURE
and enable spare key programming switch. If programming procedure is successful, new key(s) will start vehicle and THEFT indicator light will illuminate for 3 seconds. If programming procedure is not successful, new key(s) will not start vehicle and THEFT indicator light will flash for one minute (after flashing for one minute, THEFT indicator light will flash fault code). If necessary, repeat programming procedure. If programming of key(s) is still unsuccessful, check for Diagnostic Trouble Codes (DTCs) and repair as necessary. See SELF-DIAGNOSTIC SYSTEM
. Maximum of eight keys can be programmed into system. If procedure is not performed as outlined, programming procedure will end. Ignition keys must have correct mechanical key cut for vehicle and must be an encoded key.
- Insert the first programmed ignition key into ignition lock cylinder. Turn ignition switch from OFF position to ON position (ignition switch must stay in ON position for one second). Turn ignition switch to LOCK position and remove ignition key from ignition lock cylinder.
- Within 5 seconds of turning ignition switch to OFF position, insert second programmed ignition key into ignition lock cylinder. Turn ignition switch from OFF position to ON position (ignition switch must stay in ON position for one second). Turn ignition switch to LOCK position and remove second ignition key from ignition lock cylinder.
- Within 10 seconds of turning ignition switch to OFF position, insert a NEW unprogrammed ignition key into ignition lock cylinder. Turn ignition switch from OFF position to ON position (ignition switch must stay in ON position for one second). Turn ignition switch to LOCK position and remove ignition key from ignition lock cylinder. The NEW ignition key should now be programmed. To program additional key(s), repeat key programming procedure from step 1) .