Using Ignition Switch

Close all doors. Ensure ignition switch is in OFF position. Within 30 seconds, perform the following steps:

1. Turn ignition switch to RUN position.
2. Press driver's power door lock UNLOCK button 3 times.
3. Turn ignition switch to LOCK position.
4. Turn ignition switch to RUN position.
5. Horn should chirp, indicating RAP module is in enable/disable mode.
6. Press driver's power door lock UNLOCK button once to command autolock feature OFF.
7. Press driver's power door LOCK button once to enter command.

RAP module should chirp horn once to confirm autolock has been disabled. If one chirp is heard, followed by a longer sound of horn, autolock has been enabled. To disable, repeat step  7. To exit enable/disable mode, turn ignition switch to LOCK position.