LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2001 >> Windstar Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Basic Diagnostic Procedures >> No-Start Diagnosis >> Distributor Ignition System >> Spark Output Check
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Spark Output Check

  1. Check for trouble codes stored in PCM and repair if necessary. See QUICK TEST in SELF DIAGNOSTICS - EEC-V - CNG & GASOLINE article. If no trouble codes are retrieved, check ignition system wiring harness connectors for damage, corrosion and tight fit.
  2. If no fault codes are retrieved and vehicle will start, go to TROUBLE SHOOTING - NO CODES - EEC-V - CNG & GASOLINE article. If no fault codes are retrieved and vehicle is a no-start, connect a high-output spark tester between ignition coil wire and engine ground. Check for spark at coil wire while cranking engine. A consistent Blue spark should be present.
  3. If spark is present, go to step  4. If no spark is present, remove distributor cap and crank engine to ensure distributor rotor rotates. If okay, check resistance of coil secondary wire. On Villager, resistance should be less than 9100 ohms per foot. On all models except Villager, resistance should be less than 7000 ohms per foot. Service coil wire if necessary and retest. If spark is not present, go to TEST A in SELF DIAGNOSTICS - EEC-V - CNG & GASOLINE article.
  4. If a consistent Blue spark is present at coil wire during cranking, inspect distributor cap and rotor for cracks or carbon tracking. Service as necessary and test spark output at spark plugs. If spark is present at spark plugs and engine will not start, go to TROUBLE SHOOTING - NO CODES - EEC-V - CNG & GASOLINE article.
scientia non olet · About LEMON Manuals