LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2001 >> ZX2 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 439 (Module Configuration System) >> General Procedures >> Programmable Module Installation >> Using The Worldwide Diagnostic System (WDS) When The Original Body Chassis Electrical Module Is Not Available
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Using The Worldwide Diagnostic System (WDS) When The Original Body Chassis Electrical Module Is Not Available

WARNING: This page is about a different car, the 2002 Ford Windstar. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the new module.
  2. Connect the WDS and ID the vehicle as normal.
  3. From the Toolbox icon, select and highlight: Module Programming and then highlight the module that was installed and press the check mark.
  4. Select and highlight: Programmable Module Installation and then highlight the module that was installed then press the check mark.
  5. Follow the on-screen instructions and turn the ignition key to the OFF position and press the check mark.
  6. The WDS will retrieve the module data from the PCM and automatically download the data into the new module and display Module Configuration Complete.
  7. If the data is not available in the PCM, the WDS will display a screen stating to contact the As-Built Data Center.
  8. Enter the module data.
  9. WDS will download the data into the new module and display.
scientia non olet · About LEMON Manuals