Master Window/Door Lock Switch
NOTE:
For corresponding harness connector wire colors, refer to appropriate wiring diagram. See WIRING DIAGRAMS .
Remove left front door master window/door lock switch from vehicle. See POWER WINDOW SWITCH under REMOVAL & INSTALLATION. Using an ohmmeter, check continuity between specified component terminals while operating switch. See appropriate MASTER WINDOW/DOOR LOCK SWITCH TESTING table. See Fig 1 or Fig 2 . Replace switch if resistance between specified terminals is 5 ohms or more. DO NOT measure resistance between terminals not specified.
MASTER WINDOW/DOOR LOCK SWITCH TESTING (ESCORT)
| Switch/Position | Between Terminals No. | |
|---|---|---|
| Lock-Out/Up | 8 & 9 | |
| Left Front | ||
| Up | 5 & 9 | |
| Down | 4 & 9 | |
| Right Front | ||
| Up | 9 & 13 | |
| Down | 9 & 12 | |
| Left Rear | ||
| Up | 3 & 9 | |
| Down | 2 & 9 | |
| Right Rear | ||
| Up | 9 & 11 | |
| Down | 9 & 10 | |
MASTER WINDOW/DOOR LOCK SWITCH TESTING (ZX2)
| Switch Position | Between Terminals No. | |
|---|---|---|
| Left | ||
| Up | 6 & 12; 10 & 13 | |
| Neutral | 6 & 12; 7 & 13 | |
| Down | 6 & 10; 7 & 13 | |
| Right | ||
| Up | 8 & 14; 11 & 15 | |
| Neutral | 8 & 14; 9 & 15 | |
| Down | 8 & 11; 9 & 15 | |