Inspection and Verification
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
This article provides step-by-step module configuration procedures. Carry out the programmable module installation (PMI) procedures in this article when another workshop manual article directs to carry out configuration or when DTCs from the below list are present:
DTC CHART
| DTC | Description | Source | Action |
|---|---|---|---|
| B2477 | Module Configuration Failure |
|
CARRY OUT PMI. REFER to Programmable Module Installation . |
| B2900 | VIN Mismatch |
|
CARRY OUT PMI. REFER to Programmable Module Installation . |
| P0602 | Powertrain Control Module Programming Error |
|
CARRY OUT PMI. REFER to Programmable Module Installation . |
| P0605 | Internal Control Module Read Only Memory (ROM) Error |
|
CARRY OUT PMI. REFER to Programmable Module Installation . |
| P1635 | Tire/Axle Out of Acceptable Range |
|
CARRY OUT PMI. REFER to Programmable Module Installation . |
| P1639 | Vehicle ID Block Corrupted, Not Programmed |
|
CARRY OUT PMI. REFER to Programmable Module Installation . |
| U0300 | Internal Control Module Software Incompatibility |
|
CARRY OUT PMI. REFER to Programmable Module Installation . |
| U2050 | No Application Present |
|
CARRY OUT PMI. REFER to Programmable Module Installation . |
| U2051 | One or More Calibration Files Missing / Corrupt |
|
CARRY OUT PMI. REFER to Programmable Module Installation . |