Inspection and Verification
WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
This article provides step-by-step module configuration procedures. Carry out the PROGRAMMABLE MODULE INSTALLATION (PMI) procedures when another article directs to carry out configuration or when DTCs from the below list are present:
NOTE:
Some modules on this vehicle utilize a 5-character DTC followed by a 2-character failure-type code. The failure-type code provides information about specific fault conditions such as opens, or shorts to ground. Continuous memory DTCs have an additional 2-character DTC status code suffix to assist in determining DTC history.
DTC CHART
| DTC | Description | Source | Action |
|---|---|---|---|
| B2477 | Module Configuration Failure |
|
CARRY OUT Programmable Module Installation (PMI). REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| B2900 | VIN Mismatch |
|
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| P0602 | Powertrain Control Module Programming Error |
|
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| P0605 | Internal Control Module Read Only Memory (ROM ) Error |
|
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| P1635 | Tire/Axle Out of Acceptable Range |
|
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| P1639 | Vehicle ID Block Corrupted, Not Programmed |
|
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U0300 | Internal Control Module Software Incompatibility |
|
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U0300:00 | Internal Control Module Software Incompatibility: No Sub Type Information |
|
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U0300:51 | Internal Control Module Software Incompatibility: Not Programmed |
|
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U201A:51 | Control Module Main Calibration Data: Not Programmed |
|
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U2050 | No Application Present |
|
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U2051 | One or More Calibration Files Missing/Corrupt |
|
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information |
|
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information |
|
CARRY OUT APIM programming. REFER to ACCESSORY PROTOCOL INTERFACE MODULE (APIM) PROGRAMMING . |
| U2100:56 | Initial Configuration Not Complete: Invalid/Incompatible Configuration |
|
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information |
|
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information |
|
CARRY OUT APIM programming. REFER to ACCESSORY PROTOCOL INTERFACE MODULE (APIM) PROGRAMMING . |
| U2200:00 | Control Module Configuration Memory Corrupt: No Sub Type Information |
|
INSTALL a new RCM . REFER to RESTRAINTS CONTROL MODULE (RCM) . CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U3000:46 | Control Module: Calibration/Parameter Memory Failure |
|
INSTALL a new RCM . REFER to RESTRAINTS CONTROL MODULE (RCM) . CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U3002:62 | Vehicle Identification Number: Signal Compare Failure |
|
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |