Programming VID Block For Replacement PCM

A new PCM will contain the latest strategy and calibration level for a particular vehicle. However, the VID block will be blank and will need programming. There are 2 procedures available. The first is an automatic data transfer from the old PCM to the new PCM and the second is manual data entry into the new PCM.

Automatic data transfer will be performed if the old PCM is capable of communicating. This is done by the use of a scan tool to retrieve data from the old PCM before removing it from the vehicle. The stored data can now be downloaded to the new PCM after it has been replaced.

Manual data entry must be performed if the old module is damaged and/or incapable of communicating. Remove and replace the old PCM. Using a compatible Scan Tool select and execute MODULE/PARAMETER REPROGRAMMING referring to the manufacturers users manual. Important, make certain that all parameters are included. Failure to properly program Tire Size in revolutions per mile, (rev/mile equals 63,360 divided by the tire circumference in inches) Axle Ratio, 4x4/4x2, and/or Manual/Electronic shift on the fly (MSOF/ESOF) may result in codes: P1635, P1639. You may be instructed to contact the AS BUILT data center for the information needed to manually update the VID block with the scan tool. Contact the center only if the old PCM cannot be used or the data is corrupt. For Ford Lincoln Mercury technician's, contact your National Hotline or the Professional Technician Society (PTS) web sight for AS BUILT data. Non Ford technicians, use the Fed World web site at fedworld.gov. Select AUTO SERVICE INFORMATION and search for CALIBRATIONS or VEHICLE CALIBRATIONS then specify vehicle manufacturer, model name and model year as required.