Component Testing Procedure
WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
MULTIFUNCTION SWITCH COMPONENT TESTING
| Circuit to test | Connect self-powered test light or ohm-meter to terminals | Move switch to these positions | A good switch will indicate |
|---|---|---|---|
| Turn signal | 2 and 8 | Left turn | Closed circuit |
| 3 and 8 | Right turn | Closed circuit | |
| Flash-to-pass | 6 and 8 | Pull and hold lever stalk toward steering wheel | Open circuit |
| 4 and 8 | Closed circuit | ||
| High beam / Low beam | 6 and 8 | Lever stalk in detent toward steering wheel | Closed circuit |
| 4 and 8 |